60hz 220V R410a Wall Mounted AC Unit 24000btu Air Conditioner For Small Room

UA Panel 60hz 220V R410a On-Off 24000BTU Heating Cooling Highquality Door Mounted Cabinet Air Cooling Unit AC Electrical

Generally, it includes cold source/heat source equipment, cold and hot medium transmission and distribution system, terminal equipment and other auxiliary equipment. It mainly includes refrigeration host, water pump, fan and piping system. The terminal device is responsible for using the cold and heat from the transmission and distribution to specifically process the air condition so that the air parameters of the target environment meet certain requirements.

Wall-mounted air conditioners are widely welcomed by everyone, and the technology is constantly innovating. You should pay attention to comparing the functional differences of each brand.

① The startup of the inverter air conditioner is a soft start, no inrush current, and no waste of electricity.

② When the inverter air conditioner is in operation, the high frequency operation temperature rises first. When the room temperature reaches the set temperature of the air conditioner, the air conditioner becomes low frequency operation and keeps warm without shutting down. The power consumption of continuous low-frequency operation is only one-third or even one-fourth of the rated power. The same goes for refrigeration.

③ Inverter air conditioners do not have electric auxiliary heating elements that consume a lot of electricity.

To sum up, the continuous low-frequency operation of inverter air conditioners has neither frequent start-up inrush current nor long-term high-power operation like fixed-speed air conditioners, and there is no electric auxiliary heating element that consumes electricity. Therefore, inverter air conditioners are better than fixed-speed air conditioners. Speed air-conditioning saves energy and electricity.

In 2015, Yuetu moved to Ninghua from Wenzhou, and covering an area with 300,000 square meter. There are total 12 production lines with 3 million sets production capacity annually and 95% of the parts self produced, such as heat exchanger, welding, bending, automatic coating, plastic injection, and so on.